4 Ways To Deal With Boonedox Landing Gear Problems 

boonedox landing gear problems
boonedox landing gear problems

Having landing gear on your kayak can make it effortless for anglers to get their kayak from the vehicle to the water. It is quite simple to engage the Boonedox landing gear, and you won’t have to go through any excessive installation steps to get the desired performance. So, if you’re struggling to move the kayak from one position to another, then going with a Boonedox landing gear will serve you perfectly. With that said, there have been a few reports on some common problems with the Boonedox landing gear. Most of these issues are quite easy to fix, so let’s go through a few of these problems and how you can solve them.

Boonedox Landing Gear Problems

1. Gear Not Engaging

It is not that rare for users to complain about the landing gear not ensign properly as they take their kayak from the vehicle. So, if you’re in a situation where you need to use excessive force to engage the gears, then there is a good chance that pivot points have locked up. To fix this problem, you will need to inspect these pivot points and clean any rust collected in this section.

Aside from cleaning the rust, adding a bit of grease to the pivot points can also improve the overall functioning of the unit. So, depending upon the severity of the issue, you can rely on any rust cleaner from the market or go with grease to lubricate the pivot points.

2. Installation Problems

There have been a ton of reports where users mentioned installation issues with their Boonedox landing gear. Most of these issues with the installation can be traced back to the Hobie units. So, if you’re also trying to install this landing gear on a Hobie unit, there is a good chance that you’re running into compatibility issues.

To be sure, you need to browse through the compatibility list given on the Boonedox official page. Similarly, many users have talked about these combability options on the fishing forums online. So, if you’re using a Hobie kayak, it is better to reach out to the dealer and request a replacement. Otherwise, you won’t be able to get the desired performance from the landing gear, and it will keep getting stuck on the kayak.

3. Bolts Coming Loose

Aside from the comparability problems, it is not that rare to see users complaining about loose bolts and fittings on this landing gear. If you’ve not cleaned the unit in a long time and the landing gear is used in rough situations, then the only thing you can do is change the route and follow a smoother path to minimize vibrations.

Otherwise, the bolts will keep coming loose, and you will likely struggle with engaging the landing gear beneath your kayak. On top of that, you will start to hear a clanking onus e from the system. So, if you’re dealing with noise problems, then tighten up the bolts and test out the unit again.

4. Wobbling Problems

If the landing gear has an excessive wobble and you are sure that there are no bumps in the path, then you’re likely dealing with a wheel problem. Damaged sections on the wheels, as well as issues with the screws, can lead towards these issues with a rough ride. So, there is a good chance that you’re in the same situation and your wheels need tightening up to get rid of the excessive wobble.

On the other hand, if there is damage on the wheels, then the only thing you can do is reach out to the dealer regarding this issue. Forwarding a warranty claim will let you land on a replacement for free, and you won’t have to spend any money on a new unit. So, engage the dealer if you’re in possession of a valid warranty.

All in all, these are a few things that you need to consider if you’re purchasing this landing gear. The most important thing here is to check the compatibility if you own a Hobie kayak. That will help you avoid a bad purchase, and you won’t have to worry about any performance issues in the landing gear. So, make sure to seek help from an expert if you’re unsure about the compatibility of your kayak.

Leave a Comment