Evinrude Trim Gauge Not Working? Try These 3 Helpful Tips

evinrude trim gauge not working
evinrude trim gauge not working

While dealing with the electrical units on your boat, you’ll find that the majority of issues trace back to poor maintenance of the wiring cluster. Most of the time, rust will build up between the connection points and disrupt the flow of power to the sender. So, if you’re struggling with issues with any electrical component on your unit, it is a good idea to look into the wiring situation. There have been many reports on the Evinrude trim gauge not working. If you’re also stuck in a similar issue, then the following troubleshooting methods should help you around this option.

Evinrude Trim Gauge Not Working

1. Check Sender

If you’re struggling with the performance of the trim gauge, then you should start with the inspection of the sender. Depending upon the age of your unit, it is quite common to run into issues with a defective sender. So, just grab a multimeter and check the terminals of the sender. If you don’t see any reading while adjusting the angle, then there is a good chance that you’re dealing with a defective sender.

The best thing to do here is to install a replacement unit on the sender and make sure wiring connections are secured properly. Luckily, you won’t have to set aside a huge amount of money to purchase a sender replacement. On top of that, you will have to follow a few basic steps to install this replacement.

2. Clean Connection Points

In some situations, you won’t have to do anything extensive to fix the functionality of a trim gauge. It is a good idea to inspect the condition of the connection points. That helps to fix the flow of power in your unit. If there is excessive corrosion on the connection points, your best bet is to rely on a vinegar solution to remove the rust.

All you have to do is dilute the vinegar solution by a substantial proportion and use a damp cloth to clean away the rust. After that, you can wipe away the residue with a clean cloth and then secure the connection points again. Everything will start working perfectly at this point. Hopefully, you won’t have to worry about the same problem again.

3. Call Customer Support

If your unit is under warranty, then your best option is to call customer support. Simply explain this issue to them. That way, you won’t have to pay for any replacement components as the warranty policy will cover all issues. So, make sure to involve the dealer if you purchased this unit recently.

On the other hand, if your warranty is not valid, then you can seek a professional opinion from the experts working in customer support. It will be much easier to isolate the problem by seeking help from these experts. So, instead of trying to isolate the problem yourself, you should let professionals help you narrow it down. That way, you won’t have to waste any time in guessing the issue. You can implement specific troubleshooting steps to get the unit working again.

Leave a Comment