3 Ways To Fix Hawkeye Depth Finder Not Working

hawkeye depth finder not working
hawkeye depth finder not working

Even though the installation of units like a depth finder can be somewhat expensive, they can help you a lot in maximizing the efficiency of your fishing trip. So, if you’re in a situation where you are not getting lucky with fishing spots, then relying on these devices will fix your problem. This is why you will notice so many anglers shifting towards the use of these products in their fishing setup. Recently there have been some questions regarding the Hawkeye depth finder not working. If you’re also having issues with this device, then the solutions here should help you around the problem.

Hawkeye Depth Finder Not Working

1. Check Fuse

Most often than not, the issue with a depth finder not working can be traced back to a faulty fuse. So, if you’re in a situation where the Hawkeye depth finder is not working, try starting the troubleshooting process with the inspection of the fuse. If you’re lucky and there are no severe issues with the unit, then there is a good chance your fuse is blown as well.

To get around this issue, you will need to access the blown fuse and install a replacement. You won’t have to do anything else, and as long as the wiring is in perfect shape, the depth finder will start working. So, replace the fuse and boot up the unit again. Hopefully, everything will start working, and you can move forward with your fishing experience.

2. Check Wires

Issues with kinked wires and corroded connection points are also quite common when you’re dealing with these devices. So, if you’re sure that the fuse is not blown, just grab yourself a multimeter and start inspecting the wiring. That way, it will be much easier to isolate the problem, and you can replace the kinked wires to fix the issue.

Similarly, it is not that rare to run into issues with excessive corrosion on the connection points. So, you’ll need a diluted vinegar solution to get ahead of this problem. Just clean the rust of the connection points and secure the wires again. At this stage, your depth finder should start working if there is nothing wrong with the unit itself.

3. Call Dealer

If you’re still unable to get ahead of the issue with your depth finder, then you will need to call the dealer. There is a good chance that you’re dealing with a defective unit and the best thing that you can do is claim the warranty. So, make sure to involve the dealer and explain the issue to him.

If the warranty is valid, you will be able to get a replacement for free. On the other hand, if the warranty has expired, then the expert will make it easier to isolate the problem. After that, you can purchase the replacement components yourself and install them on your unit. So, even if your unit is not under warranty, make sure to seek help from professionals. That way, you won’t have to spend hours stuck in the same issue.

Leave a Comment