How To Calibrate Lowrance Ghost? (5 Simple Steps)

how to calibrate lowrance ghost
how to calibrate lowrance ghost

Just like all the units with autopilot features, you will have to first calibrate Lowrance Ghost to make use of these features. Otherwise, the performance will be inconsistent, and you’ll just be struggling with every autopilot feature, including anchor lock. So, to avoid this complication, make sure to follow the instructions mentioned in the manual step by step when installing the motor.

Many users have recently been confused about how to calibrate Lowrance Ghost, and you will see quite a few queries on this process. So, if you’re in the same situation, try following the information mentioned here.

How To Calibrate Lowrance Ghost?

Once the Lowrance Ghost unit has been fully installed on your boat, you can go through the basic calibration pretty easily by following the system instructions. There are no complicated steps involved, and you just have to follow through with these steps.

  1. To start, you need to find a calm spot with minimal waves so that there are no interferences with the calibration process. So, try to find a spot and wait a bit for calmer weather before calibrating the machine. Furthermore, you’ll need enough space to fully complete 360-degree turns during the calibrations.
  2. After finding a good spot, you need to press and hold down on buttons two and three to get into calibration mode. An audible beep will alert you about the calibration mode, and you can press number 3 once to proceed to hear two beeps.
  3. At this point, you need to turn your boat in one direction slightly while holding down the on and off buttons. The pace of the turn should be slow, and you need to make a complete circle on the water to complete the calibration in this mode.
  4. Once you hear the three beeps, this will mark the completion of the calibration, and you should be pointing in the direction that you started in.
  5. Lastly, you need to press and hold the number 1 and 2 buttons for a few seconds to get your motor out of the calibration mode. You will hear three beeps one more time when the calibrations are completed, and after that, you are free to test out the anchor mode and other smart features.

Overall, these were some basic steps that you need to follow, and if the water is rough, the waves will mess up the calibration. During the turn, you won’t be able to end the circle where you started, and you will either overshoot or come short of the circle while calibrating the motor. So, you need to make sure that the water conditions are calm and then try to calibrate the device.

Ideally, you want to finish the turn in almost the same location as you started. That way, the accuracy of the autopilot mode will be much better, and there won’t be any issues with the system. So, make sure to pick a calm spot and then proceed with the calibrations. You can also reach out to the local experts if you’re not too sure about how to manage this process.

Leave a Comment