How To Install A Raymarine Transducer (In 5 Easy Steps)

how to install a raymarine transducer
how to install a raymarine transducer

Installing a new sonar system on your boat is not always the most pleasant task, and you will have to spend quite a few hours managing the sonar system. Most anglers like to avoid hiring an expert because of the extra fees, but seeking help from a professional will help you avoid functionality-related issues with the system. So, instead of only focusing on the budget, you should prioritize the proper installation of the sonar system. A common query that many anglers have come forward with recently is how to install a Raymarine transducer. So, here are a few specifics on how to go about installing the Raymarine Transducer.

How To Install A Raymarine Transducer

Depending upon the slope of your hull and the shape of the transducer, you have to aim for minimal turbulence through the system. Otherwise, the transducer will struggle to project a steady image, and you won’t get any valid information on the display. So, make sure to carefully inspect the shape of your hull and the transducer before following these steps to install a Raymarine system.

  1. To start, you need to find a spot on your transom where the bottom section of the transducer is submerged under water at all times. Depending upon the deadrise of the boat, the location can vary, and you will run into performance issues if the bottom section of the transducer is not submerged at all times.
  2. Once you have a rough idea of where the transducer will be installed, you can rely on the mounting template to keep track of the drilling sections. Make sure to accurately place the template as you can’t go back after drilling the mounting holes.
  3. After drilling the holes, you can attach the mounting plate to the transom, and some users prefer to use sealants from the market to further secure the connection with the transom.
  4. At this stage, you can attach the transducer to the mount and adjust its position according to the deadrise on your boat. Make sure that the cables are routed perfectly and that there are no issues with the mount placement.
  5. Lastly, you just need to add clamps to the cables to avoid entanglement issues and then power up the transducer. Verify that the cables are in good shape, and you can test out the performance of the transducer on the next trip.

The only complicated step here is finding the right angle for the transducer after you pick a spot for the mourning bracket. You can’t do anything else besides trial and error to perfect the angle. So, make sure to take your unit for a few test rounds and keep adjusting the position of the transducer if you’re struggling with the results.

Ideally, your best bet is to seek help from a professional if you’re not that experienced in working with Fishfinder. This will not only save you a lot of time, but you will also enjoy better fishing results. So, instead of spending hours on the installation, just spend a few bucks on hiring an expert.

Leave a Comment