How To Remove Power Trim From Mercury Outboard (Step By Step Guide)

how to remove power trim from mercury outboard
how to remove power trim from mercury outboard

You should take issues with the trim motor on your outboard seriously as they can impact the performance of your system by a massive margin. On top of that, you’ll struggle with oil collecting the cylinders of your outboard. So, make sure to call an expert if your trim motor is not working and you’re struggling to manage the angle of your unit. With that said, there have been a few queries on how to remove power trim from Mercury Outboard. If you’re interested in a similar question, then the following solutions should help.

How To Remove Power Trim From Mercury Outboard 

The basic method for removing the power trim from the outboard can vary depending upon the model of the outboard you’ve installed on your system. So, make sure to go through the owner’s manual if you can’t seem to find the proper removal method for the power trim. With that said, let’s cover how to remove power trim from the mercury outboard.

  1. To start, you will need to get rid of the clamps fixing the wiring to the transom. After that, use the controller to raise the outboard to up position and use the lever to lock up the motor in a secured position. Make sure that the outboard has proper support, or it can lead to many accidents.
  2. After securing the outboard, you can remove the power wires from the solenoid and then use the filler section to remove all the pressure from the system.
  3. At this stage, you can remove the mounting bolts from the transom to loosen up the main section and the end of the tilt tube.
  4. Now, remove screws securing the tilt section with the transom bracket. This will free up the power trim section, and you’ll have only the cross pin holding the power trim section. You won’t have to use any power tools, and a basic tool kit should be enough to remove the power trim.
  5. Lastly, you just have to push out the swivel pin from the section and remove all screws securing the trim system with the assembly. After that, carefully pull the system away from the outboard, and it should come off the mounting brackets without any issues. However, if there is excessive rust or corrosion on your unit, then you will have to use some force to free up the trim section.

All in all, these are a few basic steps that you need to keep in mind when removing power trim from the Mercury outboard. The only crucial step in this process is securing the motor with lock levers. If the motor is not properly set, it can fall on your head when you’re removing the bolts from the transom bracket. So, to be on the safe side, make sure to provide additional support to the motor.

The installation instructions are also available on the owner’s manual, and it should take you more than an hour to replace the power trim on your outboard. Only a few basic tools are enough to remove screws and drive out the cross pin from the motor.

Leave a Comment