6 Quick Solutions To Humminbird Helix 7 Down Imaging Not Working

humminbird helix 7 down imaging not working
humminbird helix 7 down imaging not working

Humminbird Down Imaging uses a high-frequency, razor-thin beam to create photographic-like images of structures, vegetation, and fish. Side Imaging returns resemble traditional sonar returns that lookup, whereas Down Imaging returns compare standard sonar returns that look down. If the down imaging on your Humminbird Helix 7 is not functioning, try one of the following solutions:

Fixing Humminbird Helix 7 Down Imaging Not Working

1. Analyze Your Humminbird Helix 7

To determine if the depth sounder is faulty, set all settings to “Auto” or “Restore Default.” Resetting preferences helps. Try a boat with the same model number and equipment. If your gadget works on another boat with the same model, the installation, accessories, or cord is the problem.

2. Transducer Inspection

Check the cable and Operations Manual to ensure you have the proper transducer. Install the transducer on your trolling motor or transom. This transducer offers side and bottom measurements. This transducer shouldn’t be near other transducers, speed/temperature gauges, or the motor. This stops the signal from reaching the transducer. When connecting a down scan transducer to a trolling motor, consider this.

3. Marine Growth

Verify the transducer’s bottom for marine growth or other obstacles. However, some antifouling coatings can only be used thinly. Soap, water, or sandpaper can be used to clean the bottom of the transducer. Using this method, the transducer is adequately hydrated. Transducer “eyes” can develop air bubbles in the water. Palming it will help you get rid of it.

4. Connectors and Pins

Before use, check transducer, depth-sounding, fuse, and battery terminal connections for corrosion. If there’s corrosion, use abrasives or baking soda and water. Corrosion can weaken the depth sounder’s signal or voltage. Check each connector’s pins for damage. Straighten crooked connector pins with needle-nose pliers. Broken pins need replacing with the complete attachment. Bending a connector pin may shatter it.

5. Check the Cables

Examine the transducer and its cord for nicks, cuts, or other damage. Use electrical tape to attempt to repair any wire cuts. The entire accessory must be replaced if the internal wires have been severed or separated. Those broken transducers should be replaced.

Move all the transducer cables that enter the connections to determine if there is an intermittent connection. If a cable is malfunctioning, you must replace the entire transducer.

6. Check for Electrical Interference

Ensure that the boat is still, all electrical devices are off, and the motor(s) are not running before checking your depth sounder. This eliminates any potential source of trouble. If this resolves the problem, other electrical equipment on your yacht interferes with the depth sounder.

Turn each piece of equipment back on until the problem returns to find the interfering piece. The last part of equipment turned on interferes with the depth sounder. Try this with a slow main engine and fast trolling motor.

Leave a Comment