3 Ways To Resolve Minn Kota Terrova Foot Pedal Problems 

minn kota terrova foot pedal problems
minn kota terrova foot pedal problems

Depending upon the water conditions, there are quite a few variations of trolling motor that can assist you through the fishing adventure. You’ll have to evaluate a lot of factors, from the size of your boat to the type of water where you’ll be using the trolling motor. Involving an expert in the purchase decision can help you make a better choice. So, make sure to seek opinions from local anglers and the professionals working at the equipment store. With that said, there have been a few queries on Terrova Foot pedal problems. If you’re using a similar unit, then the following list of problems should help you better deal with the Minn Kota Terrova foot pedal.

Minn Kota Terrova Foot Pedal Problems

1. Not Turning Right

There have been many reports regarding the Minn Kota Terrova motor not turning right after users try to engage the foot pedal. It can be quite annoying to deal with a situation where your trolling motor won’t move in one direction. Most often than not, this issue can be traced back to debris stuck on the side of the foot pedal that is blocking the input from users. So, you’ll need to get ahead of this issue to get the Terrova Foot pedal working again.

In most situations, opening up the foot pedal and removing all debris from the sides of the device should fix everything. It will only take a few minutes. You can avoid this problem in the future by following a weekly maintenance schedule. That way, you’ll be able to get perfect performance from your foot pedal. Make sure to also clear away all obstructions with a cloth. Then, wipe the cleaning agent residue with a clean cloth. After that, you can put everything back in its place and try operating the foot pedal again. It won’t run into any issues, and the motor will work perfectly.

2. Corroded Connection Points

Sometimes users also run into rust or corrosion build-up issues on the connection points. While the foot pedal might seem perfectly fine from the outside, this corrosion can create issues with the power flow. So, if you don’t follow a monthly maintenance cycle, then the moisture can create this problem quite frequently. Luckily, it is not that hard to troubleshoot this problem.

You need to open up the unit and use a brush to remove the corrosion from these connection points. Some users also recommend anglers rely on a diluted vinegar solution. So, if you’re not able to remove the rust with only the brush, relying on a vinegar solution will yield better results.

Once all the rust has been removed, you should properly secure the wires with the connection points. This should help you deal with power issues with the foot pedal. Ideally, you won’t have to deal with any other power issues, but some users have also reported problems with kinked wires. So, make sure to replace any defective wiring or broken sections in the foot pedal system.

3. Control Board Problems

Something users have complained about is that the control board will go bad after a few months of use. Now, this problem is mostly related to irregular power flow and can be managed by verifying the power output from the battery. You can rely on a multimeter for this troubleshooting process. If the control board has gone bad, then there isn’t much that you can do to fix this problem.

If you’ve recently bought the unit, then make sure to reach out to customer support or your dealer and claim the warranty. That way, you won’t have to pay for a new control board. The professionals from Minn Kota will help you get around this issue. On the other hand, if you don’t have a valid warranty, then you’ll have to spend some money on a control board replacement.

All in all, these were a few issues that you might deal with while running the Terrova foot pedal. The most common issue here can be managed by cleaning your device after every few weeks. Aside from that, it is somewhat rare for customers to run into issues with the control board. So, make sure to check all the power connections and wiring before ordering a control board replacement.

Leave a Comment